[TRNSYS-users] Turning ON-OFF Active system

[Łukasz Wątły]

 Dear David,

Thank you very much for your reply.

However, I still would like to ask about one thing, since I am not much
into this aspect. My goal is to control the flow rate of Active Layer
(ceiling heating system) within the specified range of operative
temperature. It means that I would like to switched off the active layer
when the T_operative is higher than given value and then switch on again
when the temperature drops below other value.

Thus, I wonder how is it possible to change variables that are defined in
TRNBuild (flow rate) in TRNSYS? Do you have any experience with that?

Kind regards,
Lukasz


2018-08-01 16:14 GMT+02:00 David BRADLEY <d.bradley at tess-inc.com>:

> Łukasz,
>
>   There aren't controls available within TRNBuild. Make the inlet
> temperature and flow rate to the active layer into inputs and then you can
> use whatever controls you like in the Studio to turn pumps and other
> devices on and off and thus control the temperature in the space. Make sure
> to use a short timestep (1-5 minutes) or the building will not stay
> reliably near its set points.
>
> kind regards,
>
>  David
>
>
>
> On 07/31/2018 12:12, Łukasz Wątły via TRNSYS-users wrote:
>
> Dear All,
>
> I am writing to you, since I would like to ask if there is a possibility
> to control the Active Layer - radiant ceiling heating system so that I
> could trigger it on\off whenever the airnode temperature is below or above
> the certain limit? Is there an option to do it in TRNBuild?
>
> I would be grateful for any guidance.
>
> Thanks in advance for your reply.
>
> Kind regards,
> Lukasz Watly
>
>
> _______________________________________________
> TRNSYS-users mailing listTRNSYS-users at lists.onebuilding.orghttp://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
>
>
> --
> ***************************
> David BRADLEY
> Principal
> Thermal Energy Systems Specialists, LLC
> 22 North Carroll Street - suite 370
> Madison, WI  53703 USA
>
> P:+1.608.274.2577
> F:+1.608.278.1475d.bradley at tess-inc.com
> http://www.tess-inc.comhttp://www.trnsys.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20180806/0823df57/attachment.htm>