[TRNSYS-users] Error in simulation

[Jeff Thornton via TRNSYS-users]

What was the error listed in the LIST file?  99% of the time that will show you exactly where the problem is.  You should check this file after every simulation to look for warnings, non-convergence etc.

Jeff Thornton
TESS

Sent from my iPhone

> On Jul 12, 2017, at 4:27 AM, Ismail OUHALLOU via TRNSYS-users <trnsys-users at lists.onebuilding.org> wrote:
> 
> 
> Dear Tnsys users,
> 
> I want to simulate an AHU building integrated using type 112b. Control signal of type 112b is: The fan (type 112b) is to be ON if the relative humidity of a zone is greater than 70%.
> When I run simulation, it gets blocked at a given time as shawn in figure below:
> <Capture.PNG>
> ​
> Where does the problem come from ?
> 
> Thanks in advance
> Ismail
> 
> 
> -- 
> ************************************************
> Ismail OUHALLOU
> Green building & Sustainability consultant
> 
> Morocco
> P:+212 620 548 116
> F:+212 522 326 440
> i.ouhallou at trusted-energy.com
> issmail.ouhallou at gmail.com
> 
> 
> 
> <Capture.PNG>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20170712/690de7c4/attachment-0003.htm>