[TRNSYS-users] Changing the units in the input section doesn’t work on type5f

[mcdowell at tess-inc.com]

Christian Peper-

Changing the units for the component only changes the units for the 
value entered on the screen - it does not change the units for the 
connection.  The input value still needs to be in the same units as the 
component is programmed to accept.  It is best to only change units on 
the Parameters and not on Inputs.

Regards,

Tim

---
Timothy P. McDowell
Executive Vice President
Thermal Energy System Specialists, LLC
22 N Carroll St, Suite 370
Madison, WI 53703
608-274-2577

On 2015-11-10 04:57, Christian Peper wrote:
> Hi there, for my master thesis I’m simulating a waste-water-heat
> exchanger. By using the type5f (heat exchanger – cross flow – both
> fluids mixed) I noticed that changing the units (for example input/hot
> side flow rate change from kg/h to kg/s) doesn‘t work. The data is
> given by a data reader (type9d) and linked to type5f. I’m using TRNSYS
> 16. Has someone else experienced the same problem?
> 
> Christian Peper
> Beuth Hochschule für Technik Berlin, Germany
> 
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org