[TRNSYS-users] Questions about inputs of Type48d and Type94

[Andrea Catalina Alvarado]

Dear all

I'm simulating an autonomous photovoltaic system and I have doubts about
some parameters of elements

 - Type94

Input 3: Load voltaje. I'm working with 24V (voltage of the designed
system), but I do not know what value is right, or I have to use 0
(default), or 45V (datasheet of panel: Current-Voltage & Power-Voltage
Curve).


-Type48d

Input 4: Battery voltage (BV). I put 24V which is the system voltage. But
at the same time I have connected it to the total current of battery type
47b. Can I leave this setting?, Or should I put INPUT4 in 0 (default) and
connected to the battery?, Or as I connect?

Input 5: Max battery input. I connected it to max. power of charge of
battery. But the input 5 I put a value of 0. I must leave the 0? Or change
to battery power?.

Input 6: Min. battery output. I plugged of max. power of discharge of
battery. But I put the input 6 with value 0. I must leave the 0? Or change
to battery power?.

Input 7: lower limit on battery voltaje. I plugged of discharge cutoff
voltaje (DCV), but I'm not sure if this is the proper connection.

Input 8: Power corresponding to BV. I do not know what  is the “Power
corresponding to lower limit on battery voltage during discharge”, I
connected of power corresponding to DCV of the battery, this is correct?.

Input 9: High limit on BV. I do not know what  is the “Higher limit on
battery voltage during charge”, I plugged of carge cut off voltaje to CCV
of battery, but I'm not sure.

Thanyou in advance

-- 
*Ing. Andrea Catalina Alvarado*
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20131106/06ad08f5/attachment-0001.htm>