[TRNSYS-users] type 399

[karol.bandurski at put.poznan.pl]

Dear All,

 

I try to simulate active panel with PCM material using type 399. So far I
don't have problem with passive panel (without flow in pipes), but when I
set mass flow rate higher than 0 (72 or 100 kg/h) I get error:

 

*** Fatal Error at time   :         0.100000

    Generated by Unit     :    10

    Generated by Type     :   399

    Message               : specific massflow - use more segments - see type
description

 

I have also try to increase number of loops (n_loops), but it isn't help.

 

I noticed that the same problem is in Type 399 example. Example work when
flow is 0, if not the same error appear.

 

I would be grateful for any advice.

 

Kind regards,

Karol Bandurski

 

 

---------------------------------------------------------------------------

Karol BANDURSKI Ph.D, Assistant Professor    

Faculty of Environmental and Energy Engineering 

Division of Heating, Air Conditioning and Air Protection 

Poznan University of Technology

 <https://www.researchgate.net/profile/Karol_Bandurski>
https://www.researchgate.net/profile/Karol_Bandurski

***

dr inż. Karol BANDURSKI, Adiunkt

Wydział Inżynierii Środowiska i Energetyki

Zakład Ogrzewnictwa, Klimatyzacji i Ochrony Powietrza

Politechnika Poznańska

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20220517/f211bae8/attachment.html>