[TRNSYS-users] Wall areas in TRNBuild

[ali shahrouzian]

Dear TRNSYS users,

Please discard my previous email.

Regards,
Ali

On Tue, Feb 22, 2022 at 4:45 PM ali shahrouzian <ali.shahrouz at gmail.com>
wrote:

> Dear TRNSYS users,
>
> Hi,
>
> I have created a 3-zone building using Trnsys3d, and then imported the
> generated IDF file into Simulation Studio. During my efforts to modify the
> building model in the TRNBuild environment, I noticed that the wall areas
> of the zones (in TRNBuild) were not the same as those on the sketchup
> software. Despite this, the floors have the same area. As an example, the
> south wall area on sketchup and TRNBuild is 30 m*2 and 3.75 m*2
> respectively, but the floor area is 113 m*2 on both software.
> I would appreciate any assistance in solving my problem.
>
> Best Regards,
> Ali
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20220222/6d2ee647/attachment.htm>