[TRNSYS-users] help: tracing over drawing

[David BRADLEY]

Aly,

  I don't think that there is a right or a wrong way to go about this so 
long as you are consistent. I typically use the middle of the wall in my 
measurements.

kind regards,

  David


On 12/11/2022 11:54 PM, Aly Osman via TRNSYS-users wrote:
> Dear All,
>
> I asked earlier about importing dwg to sketchup for trnsys3d and I 
> received a reply that I should trace over the lines in my zones.
> My question is since my walls are drawn in full width, where should I 
> start tracing (from the outer side or the inner side or from the 
> middle of the wall?
> image.png
> -- 
> Kind regards,
>
> Mr. Aly Osman
> MSc. Mechanical Engineering
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy System Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20221212/867da959/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image.png
Type: image/png
Size: 124356 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20221212/867da959/attachment-0001.png>