[TRNSYS-users] Type 56

[David BRADLEY]

Simona,

   I think it might be a good idea to send your *.b17 file to your 
distributor. The fact that the default mass flow rate is showing as "-1 
# J" is very strange. I just went through the procedure for adding a 
chilled ceiling in v17 and it seemed to work normally for me. It is 
possible that your *.b17 file has gotten corrupted and your distributor 
may be able to fix it or at least confirm. If you aren't sure who to 
call, please email me directly.

kind regards,

  David


On 09/05/2019 11:07, Simona Matera via TRNSYS-users wrote:
> Dear users, I am modeling a system with a radiant ceiling panel with Trnsys 17.I have inserted an active ceiling layer in the Type56 .. when I try to enter the flow rate parameters for each thermal zone, I cannot change the allowed inlet mass  flow (in which “-1 # J” is inserted by default. in addition to this problem there is no box to perform self-segmentation. Has anyone had and solved the same problem? hoping for your help, thank you.
>   Regards
> Simona
> Inviato da iPhone
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20190906/1a659738/attachment.htm>