[TRNSYS-users] Horizontal storage tank

[mohamed sarmouk]

i will try that immediatly,
Thank you Jeff

Le lun. 18 mars 2019 à 21:13, Jeff Thornton via TRNSYS-users <
trnsys-users at lists.onebuilding.org> a écrit :

> Mohamed,
>
> Open the proforma for the model in question.  Change the minimum from 1 to
> 0 and save the proforma.  Then use the REFRESH menu option to load your
> changes into the Studio.  When you drag out a new version your change
> should be apparent.  While we are talking about Type 60 please be somewhat
> careful.  Other users have reported strange behavior with that model and we
> have removed it from the standard library in newer releases.
>
>
>
> Jeff
>
>
>
> ---
> Jeff Thornton
> President - TESS LLC
> 3 N. Pinckney Street, Suite 202, Madison WI USA 53703
> Office: (608) 274-2577  Fax: (608) 278-1475www.tess-inc.com
> E-Mail: thornton at tess-inc.com
>
> On 03/18/2019 3:06 pm, mohamed sarmouk via TRNSYS-users wrote:
>
> Hello everyone,
> i am working with the *type 60j (*horizontal cylinder), in order to enter
> the height of the tank for a horizontal cylinder i should enter its
> diameter and in my case its 450 mm or 0.45 m.
> the problem is when i run the calculation an error occur *(Message  : One
> or more of the parameters entered as heights exceeds the height of the
> tank.)* i checked and i found that height of heating element 2 & height
> of thermostat 2 are set by default to 1m and the range is between [1;15]m
> so it can't be set to a value below 1m.
> would you please give me an alternative or a solution if there is one.
> kind regards.
>
> M.SARMOUK
>
> _______________________________________________
> TRNSYS-users mailing listTRNSYS-users at lists.onebuilding.orghttp://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20190318/4a355fb3/attachment-0001.html>