[TRNSYS-users] I: different results with data reader

[David BRADLEY]

Chiara,

  It is not really possible to diagnose the problem without playing 
around with the project. It can sometimes be hard to set the Type9 
parameters correctly. I would start off by setting the time step of the 
simulation to the data interval that you have specified as one of 
Type9's parameters. This will remove the impact of the interpolate/don't 
interpolate switch. My best advice (unfortunately) is to keep messing 
around with the Type9 parameters until you get the outputs that you're 
expecting.

kind regards,

  David



On 02/05/2018 10:02, chiara pinto via TRNSYS-users wrote:
>
> Inviato da Posta <https://go.microsoft.com/fwlink/?LinkId=550986> per 
> Windows 10
>
> *Da: *chiara pinto via TRNSYS-users 
> <mailto:trnsys-users at lists.onebuilding.org>
> *Inviato: *giovedì 1 febbraio 2018 12:53
> *A: *trnsys-users at lists.onebuilding.org 
> <mailto:trnsys-users at lists.onebuilding.org>
> *Cc: *chiara pinto <mailto:chiara-pinto at hotmail.com>
> *Oggetto: *[TRNSYS-users] different results with data reader
>
> Hi everyone,
>
> i have some problems with type 9e. I want to make a comparison between 
> two thermal powers, calculated using the same starting data 
> (istantaneous values) but in different ways. One of the Thermal powers 
> has been determineted on Excel and then imported on trnsys (type 9e) 
> and collegates with online plotter. For the other one, i have inserted 
> a new equation on trnsys where both the inputs that the formula are 
> the same as the previous case. Essentially the only differencech is 
> the program that i use to calculate each of them.
>
> But, when i run the simulation, i see that there are different values. 
> How is this possible? Does anyone know what could be the problem? I 
> use mode 2 for data Readers and i chose to interpolate the data.  
> Could be this the problem?
>
> Thanks a lot for the attention.
>
> Regards,
>
> Chiara
>
> Inviato da Posta <https://go.microsoft.com/fwlink/?LinkId=550986> per 
> Windows 10
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20180205/44dfe044/attachment.htm>