[TRNSYS-users] Initial value for pressure

[Jeff Thornton]

Which Type number are you using?  But I'm not sure it matters what the pressure is on the plotter at time zero.  No iterative calculations are being done at Time = 0 so other models will not be able to get this information from this type.

If your new type needs the initial pressure at time zero then simply ask for it as a parameter.

Jeff - TESS

Sent from my iPhone

> On Nov 7, 2017, at 9:06 AM, Ghady Dib via TRNSYS-users <trnsys-users at lists.onebuilding.org> wrote:
> 
> Dear all,
> 
> 
> 
> I am using the Compressed Gas Storage and I am fixing an initial pressure.
> 
> 
> 
> My question is the following: the term “initial values” means at Time = TIME0? But when I plot the pressure Vs the simulation time, the pressure at T=0 is equal to zero. 
> 
> 
> -- 
> 
>  
> Ghady DIB
> Doctorant
> Laboratoire CETHIL UMR 5008
> Groupe Energétique des Systèmes Thermiques et Frigorifiques (ESTF)
> 
> Département Génie Energétique et Environnement
> 
> INSA Lyon
> France
> Tel:+ (33) 6 33 52 96 74
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20171107/ee2434f4/attachment.htm>