[TRNSYS-users] How to define several airnodes in one thermal zone

[Wirich FREPPEL via TRNSYS-users]

Dear Jakob,

Thank you a lot for your fast reply. I must ask another question though. 
I once tried to draw two airnodes in one thermal zone (with a virtual 
surface), in order to observe the convection phenomena between both 
airnodes. However it turned out that no heat exchanges occured, despite 
the presence of an opened window in one of the thermal airnodes.

Do I need to activate something in TRNBUILD in order to observe "air 
motion" between both airnodes?

Best regards

Wirich FREPPEL
Ingenieur Doctorant en Recherche & Developpement
Societe Noirot
8 rue Louis Ampere, 02030 Laon
+33 (0)3 23 27 31 99

Le 14/10/2016 à 15:33, hotline a écrit :
> Dear Wirich,
>
> you can draw the model in Sketchup as two zones but you have to define the surface that connects the two zones with each other as virtual surface. After importing into TRNBuild, you move on of the airnodes into the other zone by rightclick on the airnode in the navigator.
>
> Best Jakob
>
>
> __________________________________________________________________________________________________
>
> Jakob Merk M.Sc.
>
> Transsolar Energietechnik GmbH
> Curiestraße 2
> 70563 Stuttgart
> Telefon: +49 711 67976-0
> Fax:        +49 711 67976-11
> Email:    merk at transsolar.com
> http://www.transsolar.com
> Transsolar: KlimaEngineering- Technologien für energieeffizientes Bauen und Nutzerkomfort in Gebäuden
> Stuttgart - München - New York - Paris
> Geschäftsführer :Diplom-Ingenieur Matthias Schuler, Diplom-Ingenieur Thomas Auer, Diplom-Physiker Stefan Holst, Diplom-Betriebswirt Dieter Schnelle
> Eingetragen beim Amtsgericht Stuttgart HRB 23347,
> Steuernummer: 99073/00911,USt-IdNr.: DE 152272639
>
>
>
>
> -----Ursprüngliche Nachricht-----
> Von: TRNSYS-users [mailto:trnsys-users-bounces at lists.onebuilding.org] Im Auftrag von Wirich FREPPEL via TRNSYS-users
> Gesendet: 14 October 2016 15:25
> An: trnsys-users at lists.onebuilding.org
> Betreff: [TRNSYS-users] How to define several airnodes in one thermal zone
>
> Hello everyone,
>
> I would like to know the steps in order to create several airnodes in one thermal zone. Is it when i draw the model in Sketchup? or the separation of the airnodes must be done in TRNBUILD?
>
> Thanks in advance
>
> King regards
>