[TRNSYS-users] External heating source in TRNBUILD

[Matt Duffy]

Dear Michael, 

I recommend that you read the following tutorial
about going from Energy Rate Control (with the QHEAT output; not
dependent on hvac equipment components) and implementing temperature
level control (with thermostats and equipment) in your TRNSYS
Simulation.


http://sel.me.wisc.edu/trnsys/downloads/tutorials_and_examples/tlc_tutorial17.pdf


Best regards, 

Matt Duffy 

On 2012-10-11 03:13, Michael Diekerhof
wrote: 

> Dear all,
> 
> I am looking for a way to simulate an external
heating source (Air to 
> water heat pump - Type 401) in combination
with Type 56.
> 
> I would like to plot the heat pump´s COP and its
compressor power 
> according to QHeat of type 56. My basic Idea was to
connect the weather 
> data to the type 56 and type 401 first and then
type 401 to the 
> building. My problem is, that i dont know how to
input an external 
> heating source in TRNBUILD.
> 
> Of course i adjust
a roomtemperature which results in Qheat which has to 
> be covered by
the heat pump. But where can i tell type 56 that its 
> heating source
is the heat pump ??? I am thankful for any suggestions.
> 
> Michael
>

> _______________________________________________
> TRNSYS-users
mailing list
> TRNSYS-users at cae.wisc.edu
>
https://mailman.cae.wisc.edu/listinfo/trnsys-users
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20121011/b7e54aad/attachment-0005.htm>