[TRNSYS-users] Type60 two or more tanks in the simulation

[George Kyriakarakos]

Dear Sunliang Cao,

I have faced comparable problems. The solution I have found works, but I
guess there must be a better one available.

What I do is I create a new Type, which is essentially a copy of the
original Type and add it to TRNSYS (as if I was developing a type on my
own). The number of copies equals the number of same components I want to
use. Since they have different type numbers it is impossible for TRNSYS to
mix them up.

This way everything works flawlessly. 

 

George

 

-------------------------------------------------------------------

George Kyriakarakos, Agricultural Engineer

MSc Energy Systems & Renewable Energy Sources

Agricultural University of Athens,

Dept. of Natural Resources and Agricultural Engineering

Iera odos street, 75, Athens 11855, Greece

Tel. +30.210.5294046 (direct), Fax: +30.210.5294023

Mobile +30.6942.046895

e-mail: < <mailto:gk at aua.gr> gk at aua.gr>

--------------------------------------------------------------------

 

 

 

From: trnsys-users-bounces at cae.wisc.edu
[mailto:trnsys-users-bounces at cae.wisc.edu] On Behalf Of SUNLIANG CAO
Sent: Sunday, March 25, 2012 4:51 PM
To: trnsys-users at cae.wisc.edu
Subject: [TRNSYS-users] Type60 two or more tanks in the simulation

 

Dear all,

During my simulation, I have found a problem that: when there are two or
more water storage tanks (Type60) in the simulation, the setting of heat
exchanger in one of the tanks will influence all the tanks.

Is there anyone who has a good solution for this problem?

Thank you very much.

Kind Regards,
Sunliang Cao 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20120325/c8de8625/attachment-0005.htm>