[TRNSYS-users] void as inter-zonal wall

Jean Marais jeannieboef at gmail.com
Mon Jul 2 06:30:45 PDT 2012


If you are using 3d sketchup plugin, then look to the virtual partition
option. This creates (when imported into trnsbuild x2 airnodes for one
zone, in essance 2 zones. bear in mind that there is no air exchange
between the two zones...for this you need to use a "coupling". It is
basically like two zones, but for the radiation exchanges.

On 2 July 2012 14:34, Eva gklezakou <gklezakoue at gmail.com> wrote:

> Dear Sirs,
>
> I model a multi-zone building and there are two adjacent zones which do
> not have inter-zonal wall between them, because of the geometry and
> the orientation I decided not to model them as one zone. How can I assign
> the lack of inter-zonal wall, is it enough if I set an air layer as the
> only wall's material? Do I have to assign any other parameter in order to
> be more accurate?
> Thank you.
>
> Regards,
> Eva
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20120702/36cae92b/attachment-0005.htm>


More information about the TRNSYS-users mailing list