[TRNSYS-users] Partload operation of Water to Water Heat Pump (Type 668)

[David BRADLEY]

Fred,
   Type668 models a single stage heat pump. There are other versions of 
the heat pump model designed to simulate the performance of multistage 
heat pumps and there are controller models to go with them.
Best,
  David


On 10/15/2010 14:04, Fred Betz wrote:
>
> Does anyone know of a way to make part load operation work in Type668?
>
> The performance maps are based on entering conditions on the 
> evaporator and condenser side. However, there is no direct way to make 
> type668 run at 10%, 50%, etc.
>
> The work around I have used in the past is dividing the performance 
> map by 50% to reflect two stages of operation and so on. Then setting 
> up valves and controls to route the flow correctly.
>
> The HP I am modeling has a 10:1 turn down ratio and I don't want to 
> make 10 heat pumps each with 10% of the total capacity of a single unit.
>
> Please advise,
>
> Fred
>
> *Fred Betz** *PhD., LEED AP
> Sustainable Systems Analyst
>
> 	
>
> 	
>
> *AEI* | AFFILIATED ENGINEERS, INC.
> 5802 Research Park Blvd. | Madison, WI  53719
>
> P: 608.236.1175 | F: 608.238.2614
> fbetz at aeieng.com <mailto:fbetz at aeieng.com>  | *www.aeieng.com 
> <http://www.aeieng.com/>*
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
>    

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20101018/8c9fc0e6/attachment-0001.htm>