[TRNSYS-users] Calling TRNEXE

[Jones Marcus]

Type '/n' after your TRNEXE command to remove the end dialog box.

Best,

Marcus

MARCUS JONES, MSc
Energy Department
Sustainable Building Technologies

AIT Austrian Institute of Technology
Österreichisches Forschungs- und Prüfzentrum Arsenal Ges.m.b.H.
Giefinggasse 2 | 1210 Vienna | Austria
T +43(0) 50 550-6387 | M +43(0) 664 210 24 15 | F +43(0) 50550-6598
marcus.jones at ait.ac.at<mailto:marcus.jones at ait.ac.at> | http://www.ait.ac.at<http://www.ait.ac.at/>
FN: 165088b HG Wien | UID: ATU46577208 This email and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient, please notify the sender by return e-mail or by telephone and delete this message from your system and any printout thereof. Any unauthorized use, reproduction, or dissemination of this message is strictly prohibited. Please note that e-mails are susceptible to change. Österreichisches Forschungs- und Prüfzentrum Arsenal Ges.m.b.H. shall not be liable for the improper or incomplete transmission of the information contained in this communication, nor shall it be liable for any delay in its receipt.

From: Jan Schneider [BBS INGENIEURBÜRO] [mailto:j.schneider at bbs-ingenieurbuero.de]
Sent: March 11, 2010 5:06 PM
To: trnsys-users at engr.wisc.edu
Subject: [TRNSYS-users] Calling TRNEXE

Dear TRNSYS users,
I tried to use the TRNEXE.exe for a parametric analysis. There for I modify the input file (*.dck) by another application. These application calls TRNEXE with an additional parameter, the path of the dck file, to open it. Afterwards the application will modify the input file and call TRNEXE for a second time.

Cause of the "Calculations completed" screen TRNEXE will not close at the end of the simulation. Hereby I will get a process and screen for each time I call TRNEXE.

Is it possible to request the end of the simulation to receive an error or finish code? How do I close the "Calculations completed" screen automatically?



I would be grateful for your help.



Best regards

Jan Schneider

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20100311/0e540337/attachment-0005.htm>