[TRNSYS-users] Embedded electrical heating

[Cramer Silkworth]

...or do you mean a system embedded into the floor or ceiling material, 
like a radiant system (missed that word 'embedded' on the first read 
through)? In that case you need to consider the mass of that material. 
Using the 'active slab' model in type 56 you could figure out the 
heating power of the system from the entering and leaving water temp and 
massflow, and consider that as your electric power. The physics of the 
model are a bit different (ie, pipe spacing and transfer dynamics) than 
the electric system would be, but it ought to be somewhat close. And you 
would need to consider a control system, like type 2, to control the 
slab system.

-Cramer

-----Original Message-----
From: A.Thome-08 at student.lboro.ac.uk 
[mailto:A.Thome-08 at student.lboro.ac.uk] 
Sent: Wednesday, July 08, 2009 8:46 AM
To: trnsys-users at cae.wisc.edu
Subject: [TRNSYS-users] Embedded electrical heating



Good afternoon everyone,

I am using TRNSYS for the first time and I have made the modelisation of 
a building using type 56 component. Now, I have to model an embedded 
electrical heating system and I don't know if I should try to model this 
directly in type 56 or if I should use another component.

Any idea?

Thank you very much.
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users at cae.wisc.edu
https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users