[TRNSYS-users] Problem with parametric run

[Janne Paavilainen]

Hi!

Here's a few tricks that may help:

1. Use short file names, i.e. rename your *.dck file from e.g. 
VeryComplicatedSystem15thSept2008version10.dck such as S10.dck. You 
still can keep your long file name in Studio, just (copy and) rename the 
*.dck that the Studio created.

2. Try to close the deck file before you run the parametric table. I.e. 
you have only the parametric table file open in TRNSED when you start 
the parametric run.

3. Do not open the *.dck file by double clicking on it in a file 
browser. Run TRNSED from the start menu and then open the deck file from 
there.


I've had all of the above solving parametric run crashes in the past 
(but I don't remember which TRNSYS build etc. and how I had installed 
TRNSYS... on separate partition etc.).

Actually the last "bug" is still valid for me, my TRNSED doesn't even 
start if I double click on a *.dck file, but crashes with "Access 
violation...". But it runs OK if I open the deck file from TRNSED.

Cheers,
Janne

-- 
-------------------------------------------------------------
Janne Paavilainen 
MSc, Doktorand
Forskare inom Energi och miljöteknik
-------------------------------------------------------------
Solar Energy Research Center SERC
Högskolan Dalarna
SE-781 88 Borlänge
-------------------------------------------------------------
tel +46 (0)23 778728
fax +46 (0)23 778701
e-mail: jip at du.se
-------------------------------------------------------------
www.du.se
www.serc.se
www.eses.org
www.uni-kassel.de/fb15/ite/solar/solnet/
-------------------------------------------------------------



Mathieu Riegger wrote:
> Dear Panagiotis,
> I had the same problem and I couldn't find a solution to do parametric 
> runs from TRNEdit. My solution is to use TRNEdit to create the 
> dck-files for the parametric runs and to run them with a batchfile 
> (see example attached; file needs to be renamed to *.bat). Therefore 
> you have to adjust the directories in the batch file and then double 
> click on the file icon. If you do not want to see the online plotter 
> or calculation progress window add /h at the end of the command in the 
> batch file to hide thes windows (see example batch file).
> Regards,
> Mathieu
>
> ------------------------------------------------------------------------
> *Von:* Panagiotis Tsekouras [mailto:ptsek at cres.gr]
> *Gesendet:* Donnerstag, 11. September 2008 14:44
> *An:* trnsys-users at engr.wisc.edu
> *Betreff:* [TRNSYS-users] Problem with parametric run
>
> Dear all,
>
> Running the simulation with a parametric table in TRNEdit the 
> following message appears:
>
> “A/ccess violation at address 004041F2 in module TRNEdit.exe. Write of 
> address 00415F60”./
>
> Does anyone know the cause of this message?
>
> Any help would be appreciated.
>
> Thank you in advance,
>
> Panagiotis Tsekouras
>
> / /
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
>