[TRNSYS-users] Controller...???

[Tasos Ioannou]

Dear Forum,

I am trying to model a type12a house with a solar hot water system. I have connected the ''temperature to load'' of the tank to the ''inlet temperature'' of the type12a house. Then in order to complete the loop I have connected the ''temperature to heat source'' and the ''flow rate to heat source'' back to the tank. Also there is a pump that is circulating the water in the loop. Could you please tell me what would be the appropriate Controller for this pump? I would like the pump to be operating when the set point temperature in the house is below the set point temperature of the house. Or, if I cannot control the loop like this there any other way? I have attached the file so you can have a visual aspect of the model. Your advice would be very helpfull.

Best Regards 

Tasos Ioannou  



      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20080918/69cefa54/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Project2.dck
Type: application/octet-stream
Size: 15611 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20080918/69cefa54/attachment-0001.obj>