[TRNSYS-users] how not to get output list file(*.lst)

[佐藤 昭一郎]

Dear David

Thanks for the swift response.
I used "NOLIST",but I could not suppress the list file.
Do I misuse "NOLIST"card?

Below is a part of deck file.
Thanks in advance.

Sato

*******************************************************************************
*** Units 
*******************************************************************************

*******************************************************************************
*** Control cards
*******************************************************************************
* START, STOP and STEP
CONSTANTS 3
START=1
STOP=24
STEP=1
* User defined CONSTANTS 

SIMULATION 	 START	 STOP	 STEP	! Start time	End time	Time step
TOLERANCES 0.001 0.0000001			! Integration	 Convergence
LIMITS 10000 10000 0				! Max iterations	Max warnings	Trace limit
DFQ 1					! TRNSYS numerical integration solver method
WIDTH 80				! TRNSYS output file width, number of characters
NOLIST 					! NOLIST statement
MAP 					! MAP statement
SOLVER 0 1 1				! Solver statement	Minimum relaxation factor	Maximum relaxation factor
NAN_CHECK 1				! Nan DEBUG statement
OVERWRITE_CHECK 1			! Overwrite DEBUG statement
TIME_REPORT 1			! enable time report statement
EQSOLVER 0				! EQUATION SOLVER statement
 

-----Original Message-----
From: David Bradley [mailto:bradley at tess-inc.com] 
Sent: Friday, June 20, 2008 6:58 PM
To: 佐藤　昭一郎
Cc: trnsys-users at engr.wisc.edu
Subject: Re: [TRNSYS-users] how not to get output list file(*.lst)

You can suppress the list file by switching the "LIST CARD" field in the Studio's component control cards from "LIST" to "NOLIST." However, before you suppress the list file, I would recommend that you make a run allowing TRNSYS to write the list file, then look at it and make sure that there aren't a lot of warnings being written there during your simulation.
Kind regards,
 David


佐藤　昭一郎 wrote:
> Dear all
>
> I use TRNSYS 16.1.
> I have trouble about getting output a big size list file(*.lst) Please tell me how not to get output list file(*.lst).
>
> Thanks in advance
> yours
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
>
>
>
>   

--
***********************************************************************
Thermal Energy System Specialists (TESS), LLC 
David BRADLEY                      2916 Marketplace Drive - Suite 104 
Partner                            Madison, WI 53719 
                                   USA
P: +1.608.274.2577
F: +1.608.278.1475
E-mail: bradley at tess-inc.com 
Web Pages:  http://www.tess-inc.com    and      http://www.trnsys.com

***********************************************************************