[TRNSYS-users] Ventilated Facade

Technical Support TechSupport at tess-inc.com
Mon Apr 28 08:46:51 PDT 2008


Davide,
 How wide is the airgap behind the wood? We wrote some models a few months
ago to simulate a similar facade that had a ceramic tile outer skin and
about a 3cm air gap behind, then concrete, then drywall. We used CONTAM
to determine the flow of air that was induced in the air gap but you
could equally well use COMIS or TRNFlow. The model interfaces with Type56
by calculating a boundary temperature between the ventilated part of the
wall and a part of the wall that is specified in TRNBuild and modeled by
Type56.
Kind regards,
 David




Technical Support Team
Thermal Energy System Specialists, LLC
2916 Marketplace Dr, Suite 104
Madison, WI 53719
techsupport at tess-inc.com

>----- Original Message -----
Subject: [TRNSYS-users] Ventilated Facade
Date: Thu, April 24, 2008 8:05
From: "Davide Cali" <davide.cali at ise.fraunhofer.de>

> Hallo,
>
> I´m Davide Calí and I´m writing my master-thesis in Fraunhofer ISE,
> Freiburg.
>
> I wrote you some time ago about a possible tool to simulate PCM (phase
> change materials) effect, but no solution was found.
>
> Now I´m looking for a tool in TRNSYS to simulate a ventilated facade. In
> external walls, the last layer is 2cm wood, and the semi last layer is AIR.
>
> The air can go through the facade and getting in and out of it.
>
> If you have any solution, please contact me.
>
> Davide Calí
> Fraunhofer ISE
> Freiburg
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
>
>



More information about the TRNSYS-users mailing list