[TRNSYS-users] help

[蓉蓉 华]

Dear all,
 
I used the TRNSYS to optimize the Ground Source Heat Pump system (GSHP). I build an optimization of GSHP in the base of studying the TRNPOT and GenOpt, It always has a mistake. I looked at the GenoptInputFile.lst. The mistake is as followed. But the system can run when I didn’t optimize. Why GenOpt can not read SAMP_C12.1.DAT(SAMP_C12.1.DAT is the data of heat pump.
 
*** Fatal Error at time   :         0.000000
    Generated by Unit     : Not applicable or not available
    Generated by Type     : Not applicable or not available
    TRNSYS Message    350 : Unable to open the file associated with an ASSIGNED logical unit number. Please check the ASSIGN statement and make sure that the file exists at the specified location
    Reported information  : Logical Unit =     48, FileName = HEATPUMPMODEL\BEIJINGWINTER\SAMP_C12.1.DAT
 *********************************************************************************************************
The Following UNIT Numbers, TYPE Numbers, and Logical Units Were Used in the Supplied TRNSYS Input File: 
                                                         4
                                                         6
                                                         9
                                                        30
                                                        31
                                                        32
                                                        33
                                                        34
                                                        48
 
Many thanks,
Bowie. Hua, DLUT
China


      ___________________________________________________________ 
雅虎邮箱，终生伙伴！ 
http://mail.yahoo.com.cn/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20070926/bfd7bdcc/attachment-0005.htm>