[TRNSYS-users] Plugin Tess Type 534

[Timothy McDowell]

Jens -
 
Since the plugin is programmed with the American standard of denoting numbers, you will need the data file to use periods for decimal points.
 
Also, the plugin is not expecting to see the comments in the file and will error out on trying to read the data file with the comments.
 
Regards,
 
Tim




---------------------------------- 
Timothy McDowell 
Executive Vice President 
Thermal Energy System Specialists, LLC 
2916 Marketplace Dr, Suite 104 
Madison, WI 53719 
Phone: 608-274-2577 
Fax: 608-278-1475 

----- Original Message ----- 
Subject: [TRNSYS-users] Plugin Tess Type 534 
From: "Jens Apel" >;jens_apel at arcor.de> 
Date: Tue, October 30, 2007 10:05 




 





Dear all,
 
I'm, using TRNSYS 16.1 with TESS libs 2.0 V1 with the simulation studio. When I configure the tank type 534 with the plugin I get the following problems. I have a tank volume of 1.83 cubic metres and a tank height of 2.69 metres and put it in exactly like that. When I then close the plugin and open the tank input file *.dat there are the correct values, but with a comma "," instead of a dot ".". So the next time I open the plugin I have got a tank volume of 1 cubic metre, a height of 83 metres and propylene glycol -- water mixture with 69 percent. So the tank takes the parameters comma separated.
Did anybody come along the same problem and knows advice? Is it possible that it is because I'm running a german operating system where the dot "." is changed to a comma ","? Can I write comments into the tank input file? I tried "*" and "!" but seemingly that didn't work.
 
Thanks for any help
 
Jens Apel
 
Technical University of Berlin

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users at engr.wisc.edu
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20071030/211763cd/attachment-0001.htm>