[TRNSYS-users] about heat transfer from outside to inside byconduction only.

[Stefan de Kool]

Dear Ray,

 

Maybe I think too simple, but can't you just take Q(t) = U *
(Tamb(t)-Tzone(t))? The U of your wall is given in the wall type manager.

 

Kind regards,

Stefan de Kool

 

  _____  

Van: trnsys-users-bounces at engr.wisc.edu
[mailto:trnsys-users-bounces at engr.wisc.edu] Namens RAJ KUMAR
Verzonden: woensdag 22 maart 2006 19:11
Aan: trnsys-users at engr.wisc.edu
Onderwerp: [TRNSYS-users] about heat transfer from outside to inside
byconduction only.

 

Hello all,
 
I want to know the amount of amount of heat transfer from outside  surface
to inside surface of wall, 
My wall configration is 15mm plaster on eitherside of 220mm brick wall,
that's all.
 
could you please guide me?, In surface output, which combination (of Ntypes)
should I take to calculate the amount of heat transfer from outside to
inside by only  conduction?. There is no active layer in my problem.
 
 
 I have gone through the balance  ouputs given in your manual (volume6) from
page 101 to 105. Cann't we analyse all  Ntypes say 901-908 in present
version?. 
 
regards,
raj

  _____  

Yahoo! Mail
Bring photos to life! New
<http://pa.yahoo.com/*http:/us.rd.yahoo.com/evt=39174/*http:/photomail.mail.
yahoo.com>  PhotoMail makes sharing a breeze. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20060323/758bf528/attachment-0001.htm>