[TRNSYS-users] Floor cooling

[s jansen]

Dear all,

I am simulatin a normal floor cooling system ( no concrete slab
activation), so the thickness of the floor is less than required by type
56 (due to the distance between the pipes of the floor).

Does anyone know if i can solve this by either assuming a thicker floor
and adjusting the lambda and weight of the floor according to this, or
by assuming a smaller distance between the pipes and keeping the mass
flow of the water the same?


Thanks in advance,

Kind regards, Sabine Jansen

______________________________________________________________________________________
Deze verzonden e-mail is door de KPN gecontroleerd op alle bekende virussen.
This outbound message from KPN has been checked for all known viruses by KPN MailScan
(IV-Scan), powered by MessageLabs.
For further information visit: http://www.veiliginternet.nl
______________________________________________________________________________________