[TRNSYS-users] Adiabatic wall

[Diego A. Arias]

Dear Héctor,

You can find a discussion about adiabatic walls in a previous emailing 
thread:
https://www.cae.wisc.edu/pipermail/trnsys-users/2005/000414.html
If you have additional questions, please feel free to email me.

Best regards,

Diego


Héctor Montoya wrote:

>Hello Trnsys users.
>
>I have to define an adiabatic wall.
>For that, I defined a boundary wall with very low convective
>coefficient at the back and with very high solar absortance at the
>back too. But problem is that I have to define a boundary temperature
>of a fictive zone. So, when I change that value of temperature to
>check the correct behavior of the adiabatic wall I get different
>simulation results.
>I am worried about that because if there is no heat exchange at the
>back of the wall (above condition) I should have the same results for
>any boundary temperature.
>
>I need some advice.
>
>Héctor Montoya M.
>Estudiante de Magíster en Ingeniería Mecánica
>Universidad de Concepción
>Concepción - Chile.
>
>_______________________________________________
>TRNSYS-users mailing list
>TRNSYS-users at engr.wisc.edu
>https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
>  
>


-- 

Diego A. Arias
TRNSYS Coordinator
Solar Energy Laboratory
University of Wisconsin - Madison
1500 Engineering Drive
Madison, WI 53706