[TRNSYS-users] Thermal storage tank (Type4a)

[David BRADLEY]

Sleiman,
   With Type4, the question about how many nodes there are in the tank 
must be answered on the parameter, the output, and on the derivative 
tabs. Be careful as the output tab asks you to tell it how many nodes 
there are besides the top and bottom nodes.
Regards,
  David


On 11/28/2012 04:10, Farah, Sleiman - farsy019 wrote:
>
> Dear TRNSYS users,
>
> I have a project (TRNSYS 16) with thermal storage tank (Type4a) using 
> "5" nodes. Whenever I use the "Update project" in the "Edit" menu and 
> run the simulation, I get an error message. However, I found by chance 
> that if I change the number of nodes of the storage tank to "1" node 
> and then change the number again to "5" the simulation runs normally.
>
> I wonder what would be the cause of this error.
>
> Regards,
>
> Sleiman
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20121203/f1c60683/attachment-0001.htm>