[TRNSYS-users] Problem with importing multizone building from sketchup 2019 to Trnsys 18.

[David BRADLEY]

Tarek,

  For some reason none of the zones that you drew in SketchUp/Trnsys3d 
were written to the *.idf file. If you did not already do so, please try 
and step through the relevant section of the 09-Tutorials manual as it 
explains the process. If you have done that and are still having 
problems I would recommend contacting your distributor for assistance.

kind regards,

  David


On 09/13/2022 09:44, Tarek El Shafey via TRNSYS-users wrote:
> I built a building using sketchup 2019 and tried to import it to 
> Studio simulation, but an error occurred. It says " At least 2 
> surfaces are required per zone ". I am attaching the modelling file in 
> idf extension. Please tell me where the problem is.
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy System Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20220915/76c18a78/attachment.htm>