[TRNSYS-users] Ssurface Temperature

[Marion Hiller]

Hi Elise,

I assume that your floor is defined as a boundary surface.
Check the defined boundary temperature of the floor. IT might be set to 0.

Marion

Von: TRNSYS-users [mailto:trnsys-users-bounces at lists.onebuilding.org] Im Auftrag von Elise BERNARD via TRNSYS-users
Gesendet: Mittwoch, 27. Juni 2018 12:33
An: TRNSYS users mailing list at OneBuilding.org <trnsys-users at lists.onebuilding.org>
Cc: Elise BERNARD <e.bernard at katene.fr>
Betreff: [TRNSYS-users] Ssurface Temperature

Hi,

I use TRNSYS to model an office building (new construction, good insulation) and check the comfort inside.
I would like to verify the surface temperature of the floor of each zone. So I use the build surface outputs 17 TSI and 18 TSO.
The set temperatures are 20°C during the day and 16°C during the night.
The surface temperature of the floor seems to be very low sometimes : 2°C or 3°C below the set temperature.
I already checked the ventilation, infiltration, heat temperature, temperature of zones nearby.

Did you already observe this kind of results ? Do you know why ?

Thanks

Elise Bernard
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20180627/7a6ff63e/attachment.html>