[TRNSYS-users] How to skip timesteps if they don't reach convergence?

[Javier Vega via TRNSYS-users]

Hello TRNSYS users,

I've noticed that some simulations finish with  messages that say that a
certain component (or components) doesn't reach convergence at certain
timesteps. The message is the following:

" The inputs to the listed units have not converged at this timestep. The
values at the last iteration will be used and the simulation will proceed."

Right now I'm doing a simulation with 5 min timestep that works well but
gets stuck at  hour 150, for example. If I change the simulation start time
everytime this happens so the simulation can continue, it keeps calculating
until  it gets stuck again 200 hours later.

I assume the TRNEXE gets stuck because of non convergence. Since the non
converged timesteps are neglectable, how can I set TRNSYS to automatically
ignore this timesteps and set the input/ouputs of the problematic units to
the previous ones?

Is there a chapter in the TRNSYS Documentation that I should check?

Thanks in advance,
Javier Vega
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20170607/39306108/attachment-0003.htm>