[TRNSYS-users] Active layers

[hotline via TRNSYS-users]

QSENS is only taking into account the ideal heating and cooling, not active layers.

You can use NTYPE 59 to output the energy flow from the fluid to the wall.

Best
Jakob

__________________________________________________________________________________________________

Jakob Merk M.Sc.

Transsolar Energietechnik GmbH
Curiestraße 2
70563 Stuttgart
Telefon: +49 711 67976-0
Fax:        +49 711 67976-11
Email:    merk at transsolar.com<mailto:merk at transsolar.com>
http://www.transsolar.com<http://www.transsolar.com/>
Transsolar: KlimaEngineering- Technologien für energieeffizientes Bauen und Nutzerkomfort in Gebäuden
Stuttgart – München – New York – Paris
Geschäftsführer :Diplom-Ingenieur Matthias Schuler, Diplom-Ingenieur Thomas Auer, Diplom-Physiker Stefan Holst, Diplom-Betriebswirt Dieter Schnelle
Eingetragen beim Amtsgericht Stuttgart HRB 23347,
Steuernummer: 99073/00911,USt-IdNr.: DE 152272639



Von: TRNSYS-users [mailto:trnsys-users-bounces at lists.onebuilding.org] Im Auftrag von Katarzyna Palaszynska via TRNSYS-users
Gesendet: 13 September 2016 07:35
An: trnsys-users at lists.onebuilding.org
Betreff: [TRNSYS-users] Active layers


I prepared simulation of room. Active layers (TABS) are the only heat and cool equipment (no radiators or fancoil). I use type 56. In the room I've got infiltration, ventilation and gains defined. Heat and cool are set as "off". With this settings Q_SENS is always 0. What should I do to obtain the proper Q_SENS value?

Regards
Katarzyna
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20160913/31036767/attachment-0003.htm>