[TRNSYS-users] How to define several airnodes in one thermal zone

[hotline via TRNSYS-users]

Dear Wirich,

you can draw the model in Sketchup as two zones but you have to define the surface that connects the two zones with each other as virtual surface. After importing into TRNBuild, you move on of the airnodes into the other zone by rightclick on the airnode in the navigator.

Best Jakob


__________________________________________________________________________________________________

Jakob Merk M.Sc.

Transsolar Energietechnik GmbH
Curiestraße 2
70563 Stuttgart
Telefon: +49 711 67976-0
Fax:        +49 711 67976-11
Email:    merk at transsolar.com
http://www.transsolar.com
Transsolar: KlimaEngineering- Technologien für energieeffizientes Bauen und Nutzerkomfort in Gebäuden
Stuttgart - München - New York - Paris 
Geschäftsführer :Diplom-Ingenieur Matthias Schuler, Diplom-Ingenieur Thomas Auer, Diplom-Physiker Stefan Holst, Diplom-Betriebswirt Dieter Schnelle
Eingetragen beim Amtsgericht Stuttgart HRB 23347, 
Steuernummer: 99073/00911,USt-IdNr.: DE 152272639




-----Ursprüngliche Nachricht-----
Von: TRNSYS-users [mailto:trnsys-users-bounces at lists.onebuilding.org] Im Auftrag von Wirich FREPPEL via TRNSYS-users
Gesendet: 14 October 2016 15:25
An: trnsys-users at lists.onebuilding.org
Betreff: [TRNSYS-users] How to define several airnodes in one thermal zone

Hello everyone,

I would like to know the steps in order to create several airnodes in one thermal zone. Is it when i draw the model in Sketchup? or the separation of the airnodes must be done in TRNBUILD?

Thanks in advance

King regards

-- 

Wirich FREPPEL
Ingenieur Doctorant en Recherche & Developpement Societe Noirot
8 rue Louis Ampere, 02030 Laon
+33 (0)3 23 27 31 99

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users at lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org