[TRNSYS-users] Double skin facade

[Avesani Stefano]

Hi all,

Concerning the modelling of a DSF in TRNSYS, I have a doubt about the solar radiation calculations reported in Balance1 (NType901) and Balance 4 (NType904).

Going from indoor to outdoor, I have an indoor office space, a double glazing, the DSF cavity and an external single glazing. In particular, comparing B4_QSOL (for the indoor space) with B1_QSADJ (for the indoor space) and B4_QSOL (for the indoor space) with B1_QSGWALL (for the indoor space) I get the following general trend:
B1_QSADJ > B4_SOL > B1_QSGWALL
Which contributions are missing in this comparison?

Moreover, I want to calculate the overall solar gain from the adjacent window going toward indoor, divided in its components (transmitted radiation direct + diffuse, secondary heat flux convective towards the indoor air and LW from the internal surface to the indoor internal walls). Is this possible with the Type56 output?

Thanks a lot!
BR
Stefano


EURAC research
Institute for Renewable Energy
Via G. Di Vittorio 16, I-39100 Bolzano
t +39 0471 055 654
f +39 0471 055 699
stefano.avesani at eurac.edu<mailto:stefano.avesani at eurac.edu>
www.eurac.edu<http://www.eurac.edu/>

EURAC research
Legal Seat
Viale Druso 1, I-39100 Bolzano

This transmission is intended only for the use of the addressee and may contain confidential or legally privileged information.
If you receive this transmission by error, please notify the author immediately by mail and delete all copies of this transmission and any attachments.
Any use or dissemination of this communication is strictly prohibited by the "Privacy-Code", D.Lgs. 196/2003 and may lead to penal prosecution and liability for damages.

P Think before you print

From: trnsys-users-bounces at cae.wisc.edu [mailto:trnsys-users-bounces at cae.wisc.edu] On Behalf Of David BRADLEY
Sent: 18 July 2013 18:15
To: TRNSYS users mailing list at the Solar Energy Lab, UW-Madison
Subject: Re: [TRNSYS-users] Double skin facade

Zahid,
  I have done some double skin facade modeling in TRNSYS. I typically treat the airspace of the double skin as a zone in the Type56 building model and then use Type97 (CONTAM) to calculate the air flow rate through that zone.
Kind regards,
 David

On 7/13/2013 02:07, m zahid wrote:
hi
Anybody know about the Double Skin facade modeling in TRNSYS .

zahid




_______________________________________________

TRNSYS-users mailing list

TRNSYS-users at cae.wisc.edu<mailto:TRNSYS-users at cae.wisc.edu>

https://mailman.cae.wisc.edu/listinfo/trnsys-users



--

***************************

David BRADLEY

Principal

Thermal Energy Systems Specialists, LLC

22 North Carroll Street - suite 370

Madison, WI  53703 USA



P:+1.608.274.2577

F:+1.608.278.1475

d.bradley at tess-inc.com<mailto:d.bradley at tess-inc.com>



http://www.tess-inc.com

http://www.trnsys.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20150810/bcb649d8/attachment-0003.htm>