[TRNSYS-users] Trnsys component

[David BRADLEY]

Badreddine,
   There are numerous ways that you can accomplish this. You could 
either write an equation or if you want your valve to have some 
hysteresis (a temperature deadband) then you can configure Type2. The 
result of Type2 or your equation would then be passed to an appropriate 
mode of Type11 (depending on whether you are talking about a diverting 
valve or a mixing valve)
kind regards,
  David


On 12/11/2014 03:34, Boutaghriout Badreddine wrote:
> Dear trnsys users,
> I'am usig trnsys 16.1, in my project, i would like to conduct a 
> simulation of a solar water heating system (forced circulation), in 
> fact,  i need to use an electro valve which is monitored by 
> temperature sensor ( if the temperature reaches a certain value the 
> electro valve is swiched on, otherwise, it is kept in the off state).
>
> So in the library of my sowtware, i haven't found this component 
> (electro valve), my question is: can i replace it by another 
> component? What are your suggestions for me?
>
>
>
> Best regards.
> Badreddine
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at lists.onebuilding.org
> http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20141211/4340b507/attachment-0004.htm>