[TRNSYS-users] TRNSYS message 129

[David BRADLEY]

Matthieu,
   One of the parameters of Type66 is the number of outputs that EES is 
going to provide. I can imagine that if you set that parameter to a 
value but then EES was passing back more than that number outputs, the 
error might be triggered.
Kind regards,
  David


On 11/26/2013 05:51, COSNIER Matthieu wrote:
>
> Dear all,
>
> I try to simulate an heating component modeled with ees software, in 
> TRNSYS environment  by using type 66a (calling  ees routines).
>
> The simulation works for few time steps but finally crash with the 
> following error message:
>
> "TRNSYS Message    129 : The referenced Unit has tried to set an 
> Output value higher than the number of Outputs that the Type reserved 
> for itself."
>
> Could someone explain me what it means?
>
> Best regards
>
> Matthieu
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20131126/54eae8bb/attachment-0001.htm>