[TRNSYS-users] Unknown Unit Number + negative flow rate errors
Currie, Sam R
scurrie at purdue.edu
Fri May 3 08:06:59 PDT 2013
Hi Damien,
The first error at the beginning of the simulation is related to a Type62 component; the unit 24 refers to the order of the components in your simulation. Check your control cards to confirm this.
As to your second error, it's difficult to tell what's going on from the snapshot. Check the lst file, it should give you more details on the errors you are getting. If you're model isn't reaching convergence as often as you indicated then it may be that TRNSYS has reached the maximum number of warnings or non-fatal errors after 1578 time steps and forced the simulation to exit. If you can't find the error from the lst file then you could try turning debug mode on (it's in the control cards menu) then rerun the simulation and check the lst file again.
Hope that helps,
Sam Currie
Purdue University
-----Original Message-----
From: trnsys-users-bounces at cae.wisc.edu [mailto:trnsys-users-bounces at cae.wisc.edu] On Behalf Of trnsys-users-request at cae.wisc.edu
Sent: Friday, May 03, 2013 10:30 AM
To: trnsys-users at cae.wisc.edu
Subject: TRNSYS-users Digest, Vol 101, Issue 6
Send TRNSYS-users mailing list submissions to
trnsys-users at cae.wisc.edu
To subscribe or unsubscribe via the World Wide Web, visit
https://mailman.cae.wisc.edu/listinfo/trnsys-users
or, via email, send a message with subject or body 'help' to
trnsys-users-request at cae.wisc.edu
You can reach the person managing the list at
trnsys-users-owner at cae.wisc.edu
When replying, please edit your Subject line so it is more specific than "Re: Contents of TRNSYS-users digest..."
More information about the TRNSYS-users
mailing list