[TRNSYS-users] Trnedit and parametric runs, trnsys output modification

[C.ARBOLEDA at sanden-europe.fr]

hi,

I'm trying to simulate a DHW system, and I would like to make a parametric 
run using TRNedit. 
In this parametric study, I would like to change the node of my storage 
tank which is use to regulate my DHW system.

In TRNedit, the TRNSYS outputs are referenced like this: [Unit#, Output#]
Is it possible to replace the Unit# or the Output# by a constant or an 
equation? 

Example:

TANK: UNIT 35 TYPE 534

[35,21] is the temperature of the 1st node of my tank

I want to replace [35,21] by [35,x], x will vary every new simulation 
following my parametric table.

I do not undertand very well the properties of the object:  [Unit#, 
Output#]

If it's not possible is there another solution to this problem?

Thank you in advance for your answer

Carlos Arboleda
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130828/5810c2e5/attachment-0004.htm>