[TRNSYS-users] Dividing by Zero

[Amir Nashed]

Dear Users

I am facing a problem where whenever I insert an equation and divide by something, it receive an error that I am dividing by zero.

I made sure that all initial conditions are not zero and I even plotted the value of the variable and it does not equal zero.

I even put a condition that the division only occur if the denominator is >0 but still the same.

Does anyone know what's causing this?

Thank you

Regards,
Amir Nashed
PhD Candidate
School of Renewable Energy and Photovoltaic Engineering
University of New South Wales
Phone:+61405979282
Email:.a.nashed at unsw.edu.au

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130815/aa18d3c9/attachment-0004.htm>