[TRNSYS-users] Surface temperature of an active layer in type 56a

David BRADLEY d.bradley at tess-inc.com
Mon Aug 26 11:06:51 PDT 2013


Ahmed,
  It sounds as though you have an incorrect connection in your project 
or as though there is a units problem (like mixing up a mass flow rate 
of ventilation air (kg/h) with an air change rate (airchanges/hr). 
Without seeing the project it is not possible to tell. I would recommend 
you contact your distributor for technical assistance.
Regards,
  David


On 8/16/2013 06:54, Ahmed Khoja wrote:
>
> Dear all,
>
> I am trying to model a wall with an active layer in type 56_a, however 
> every time i use an input in the user defined convective heat transfer 
> coefficient of wall, i get a wrong results of  the surface temperature 
> as TRNSYS prints out the ambient temperature instead of the surface 
> temperature. if i use constant value instead of an input  this problem 
> disappears. any idea how can I solve this problem.
> your help is highly appreciated,
> Thanks
> Ahmed
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130826/07ac0935/attachment-0001.htm>


More information about the TRNSYS-users mailing list