[TRNSYS-users] Type 2b auxiliary heater of a stratified storage tank
mcdowell at tess-inc.com
mcdowell at tess-inc.com
Thu Apr 11 11:17:34 PDT 2013
Rajaa -
I am not clear on what you are trying to accomplish with
your model.
If you are trying to model a tank in an environment with a
constant temperature, you can just set the environmental temperature
inputs to the tank model to a constant 55C.
Type 6 is intended to
model the heating of a fluid stream and not the air surrounding a tank.
Regards,
Tim
---
Timothy P. McDowell
Executive Vice
President
Thermal Energy System Specialists, LLC
22 N Carroll St, Suite
370
Madison, WI 53703
608-274-2577
On 2013-04-10 12:17, Rajaa Badaoui
wrote:
> Hi everybody,
>
> I'm stuck with trying to control the
outside temperature of a stratified storage tank (type534) with the
controller type2b and the auxiliary heater type6. When i first connect
only the auxiliary heater to the tank, the auxiliary heater was ON only
when there was a flow stream. Then i connected a controller to maintain
the auxiliary heater even if there is no flowrate. the outside storage
tank temperature has to be always at 55°C. But sometimes the outside
temperature of the tank is lower than 55°C. I think i put a sufficient
maximum heating rate in the type6. I connected the tank nodal
temperature to the lower input temperature of the controller
> I set
the upper input temperature of the controller to 55°C
>
> Can somebody
help me to understand why i can't maintain the outside temperature at
55°C?
>
> I'll be grateful for any advice
>
> Thanks in advance
>
>
Rajaa
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20130411/861288a2/attachment-0005.htm>
More information about the TRNSYS-users
mailing list