[TRNSYS-users] simulating a PV/T concentrator

[Mehdi Shahrestani]

Hi 
 
My thought on this issue: 
1- the deata file is not properly linked into the component
2-if the component is a new developed, might some parameters (calling
exteernal data files) are misses. Have a look on section 7.4.4 of the
programmers guide.
3- logical number is not defined in the performa (If it is new component)
 
Hope it helps
Mehdi

  _____  

From: trnsys-users-bounces at cae.wisc.edu
[mailto:trnsys-users-bounces at cae.wisc.edu] On Behalf Of Mahdi Hedayatizadeh
Sent: 25 May 2012 11:35
To: trnsys-users at cae.wisc.edu
Subject: [TRNSYS-users] simulating a PV/T concentrator


Hi,

I am simulating a PV/T concentrator through TRNSYS and while I run it, I
face a message of " Unable to open the file associated with an ASSIGNED
logical unit number " which I think is relevant to SOLCEL subroutine. As I
search to find the subroutine source, there is no use! 

Has anyone of you worked with PVT concentrator component in TRNSYS yet or
faced the same problem?

Best wishes,
Mahdi


 
-- 
Mahdi Hedayatizadeh 
Ph.D. Candidate,
Energy in Agriculture,
Department of Agricultural Machinery Engineering, 
Faculty of Agriculture,
University of Tabriz,
Tabriz, Iran.
Tel.: +98 9384772799,
Email: hedayatizadeh at tabrizu.ac.ir

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20120525/16a8e69c/attachment-0005.htm>