[TRNSYS-users] Range check error

[David BRADLEY]

Baboo,
   A Range Check Error is a generic Fortran error that can be caused by 
a number of different things (accessing an array with an index that is 
bigger or smaller than the number of entries in the array, dividing by 
zero, taking the log of a negative number). The only real way to track 
down the cause is to run a simulation that was launched from the Fortran 
compiler and walk one line at a time through the code as it executes. 
You'll get a lot of debug information that will help you find the cause 
of the problem. There are instructions for how to run a simulation from 
the debugger at the end of the Programmer's Guide manual.
Best,
  David


On 2/23/2012 12:06, Baboo Gowreesunker wrote:
>
> Dear TRNSYS users
>
> I made a component, and it works fine until the number of time-steps 
> reach 148, irrespective of the size of the time-step.
>
> I then get the:  “Range Check error”, “TRNSYS will now abort”.
>
> I believe it must be something to do with the max. number of outputs 
> from the component. Can somebody please tell how to change that ?
>
> Thanks
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20120301/b33ca2f5/attachment-0005.htm>