[TRNSYS-users] different air nodes in one zone

[Joke De Beuckelaer]

Dear all,

I've a question considering the use of the coupling tool between different air nodes. When you have for example a zone "Landscape OfficeA" that consists of two air nodes "Airnode OffA1" and "Airnode OffA2". These air nodes are adjacent to each other (does not one above the other, but one next to the oter).  (Because we can measure the temperature at two different places).
Is it necessary to define a coupling air flow between these air nodes or does the calculation does this automatically?

Also for all the technical installations (heating, cooling, ventilation...) it is possible to define this by air node. But how the influence on the other air nodes is taken into account?
Is it correct that the internal gains are only taken into account for the respective air node and thus not for the whole zone?


Thanks in advance,

Joke De Beuckelaer
project engineer mep


VK     HEALTHCARE      |      BUILDINGS      |      INDUSTRY      |      INFRA

Value by design

VK ENGINEERING  Avenue Clemenceaulaan 87, 1070 Bruxelles Brussel, Belgium
t   +32 2 414 07 77   f  +32 2 414 04 98   m  +32 473 97 01 50   e   joke.d at vkgroup.be   w   www.vkgroup.be


 ALWAYS LOOKING FOR GREAT PEOPLE<http://www.vkgroup.be/en/news/vk-s-best-wishes-for-2012>
****DISCLAIMER****
This communication is confidential and for the sole useof the addressee. If you are not the intended recipient,
please immediately notify the sender by e-mail at the address shown and then delete it from your system
without copying, disclosing or forwarding its contents. Thank you.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20120215/582a34a3/attachment-0001.htm>