[TRNSYS-users] Type 534

[David BRADLEY]

Alessia,
Since Type534 can have a lot of different configurations, it is not 
possible to know the cause of the problem without seeing the *.tpf file 
(to know what input 6 is in this case). If input 6 is a flow rate, then 
chances are that the error is because input 6 is going negative. It may 
be helpful to you to start with one of the examples of using Type534 
with an internal heat exchanger, verify that it runs, then copy the tank 
model from the example project into your project. Get the external file 
reference set up correctly then being changing the tank from the example 
configuration to your desired configuration one step at a time. The 
examples are located in
Kind regards,
David


On 7/1/2011 11:55, aartecon at mta01.univpm.it wrote:
> I'm using the storage tank Type 534 with a coil heat exchanger inside.
> I'm experiencing a lot of troubles to make it work properly.
> I got this error message, but it doesn't seem that the problem is the
> input suggested.
>
> "The TRNSYS TYPE checking routine has found an inconsistency in the
> specified component between the input file and the information expected by
> the Type
>      Reported information  : An illegal INPUT value has been reported by
> the model. The model has reported that Input 6 is the problem - but
> this may not be the case. Please check the component configuration.
> The *.lst file may contain additional information."
>
>
> Do you have any idea of what can cause the problem?
> Thanks in advance.
> Alessia
>
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users
>

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com