[TRNSYS-users] Questions about AWHP - Type 941

[Matt Duffy]

Dear Andrey,

There was an update to this component, so please make sure that you are
using the TESS Libraries 17.01 and not 17.00. You may determine this by
looking in the ".\UserLib\ReleaseDLLs" directory, and make sure that you
have the TESSHVAC*17.01.dll and not the 17.00.dll. If you do not have the
update, please contact your local TRNSYS distributor for the latest.

Best regards,

Matt Duffy

----- Original Message -----
From: "Andrey Vyshnepolsky" <andrey.vyshnepolsky at rwth-aachen.de>
Sent: Tue, February 15, 2011 9:39
Subject:[TRNSYS-users] Questions about AWHP - Type 941

Hello,

I have two questions about the AWHP Type 941:

1)
As soon as I connect the relative humidity and the ambient pressure (I
have put in
between an equation to transform the unit Pa to atm, as it is requested by
the AWHP)
from the weather data component (user defined) to the AWHP I am getting the
following error message (the humidity mode of the AWHP, Parameter1 is 2):

TRNSYS Message 103 : The TRNSYS TYPE checking routine has found an
inconsistency in
the specified component between the input file and the information
expected by the
Type  Reported information  : An illegal INPUT value has been reported by
the model.
The model has reported that Input 5 is the problem - but this may not be
the case.
Please check the component configuration. The *.lst file may contain
additional
information.

2)
No matter which value I put in for the rated heating power (Parameter15)
and the
blower power (Parameter10) the AWHP works. And this can be in no way the
case.

Best regards,

Andrey



_______________________________________________
TRNSYS-users mailing list
TRNSYS-users at cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users


----- End of original message -----