[TRNSYS-users] replace command failure

[David BRADLEY]

David,
  I have not run into that problem before. Does it give an error or does 
the "replace" command just not do anything? I would recommend sending 
the project *.tpf and the replacement proforma to your distributor to 
see if they can find the cause of the problem.
Best,
  david


On 8/12/2011 04:35, CHEZE David 227480 wrote:
>
> Hi,
>
> I need to replace a component in simulation studio project by an older 
> version : difference is only about the number of outputs which was 
> smaller than in current one. The order of the parameters, inputs and 
> outputs is the same then most of the connections could be maintained : 
> that's not what's happen in my case : can this point being improved ?
>
> Windows7 TRNSYS17.019
>
> Thanks,
>
> David Chèze
>
> tel. 0479601437 - INES, CEA/Leth  - Le Bourget du Lac (73), FRANCE - 
> bât. PUMA3 bur. 204
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20110812/dcf61105/attachment-0001.htm>