[TRNSYS-users] Front side Boundary condition

David BRADLEY d.bradley at tess-inc.com
Tue Aug 2 07:36:40 PDT 2011


Luis,
  I think the idea is that Type56 is calculating the effects of what 
happens in the zone being modeled. The front side of the wall is inside 
the zone so Type56 is going to calculate the air temperature, the wall 
surface temperature, and (if you allow it to) the convection coefficient 
between the air and wall. If you are trying to model a surface in your 
zone that is always at some known temperature then I think you are 
correct that the best way to model it would be to specify a back-side 
temperature in direct contact with a low-mass "wall." I would allow 
Type56 to calculate the convection coefficient between your surface and 
the zone air temperature since this convection coefficient is dependent 
on both the magnitude and the "direction" of the temperature difference.
Best,
  David


On 8/2/2011 03:47, Claros Marfil, Luis Jesus wrote:
>
> Hi Trnsys Users,
>
> I would like to know if it is possible to define a boundary value for 
> the FRONT SIDE of a wall directly. In page 6-103 (Type 56 - TRNSYS 16 
> Manual) it is said that : "/Normally, the boundary condition is the 
> temperature of a node connected to the back surface of the wall 
> through a pure resistance. It is possible to specify the surface 
> temperature of the outside by setting the back side heat transfer 
> coefficient of the WALL TYPE to a very small value (less than 0.001 
> kJ/h/m2)./
>
> So, I understand that if a coefficient with a value of  0,001 kJ/h/m2 
> or lower is used, the boundary temperature corresponds to the back 
> side, and the only way I find to "transform" this back side 
> temperature into a front side temperature is using a very-low 
> resistance (massless layer) by using a high convective heat transfer 
> coefficient in the front side.
>
> Any idea would be highly appreciated.
>
> Thanks,
>
> *Luis J. Claros Marfil*
>
> Grupo de Materiales Avanzados - Advanced Materials Group
>
> Centro Tecnológico I+D+i  - R & D Technology Center
>
> *ACCIONA Infraestructuras
> *
>
> __
>
> 	
>
> Valportillo II, nº8
> C.P. 28108 Alcobendas (Madrid)
> Tel.: +34  91 791 20 20
> Fax: +34  91 791 21 01
> www.acciona-infraestructuras.es
>
> **
>
> QAntes de imprimir este mensaje, asegúrate de que es necesario. 
> Proteger el medio ambiente está también en tu mano.
>
> Este mensaje se dirige exclusivamente a su destinatario, y puede contener información confidencial sometida a secreto profesional, o cuya divulgación esté legalmente prohibida. Cualquier opinión en él contenida es exclusiva de su autor y no representa necesariamente la opinión de la empresa. Si ha recibido este mensaje por error, le rogamos nos lo comunique de forma inmediata por esta misma vía y proceda a su eliminación, así como a la de cualquier documento adjunto al mismo. El correo electrónico vía Internet no es seguro y no se puede garantizar que no haya errores ya que puede ser interceptado, modificado, perdido o destruido, o contener virus. Cualquier persona que se ponga en contacto con nosotros por correo electrónico se considerará que asume estos riesgos.
>
> This e-mail is addressed exclusively to the recipient and may contain privileged information under a professional confidential agreement or it may be against the law to disclose its contents. Any opinion contained in it belongs exclusively to his/her author and does not necessarily reflect the company's view. If you receive this e-mail in error, please let us know immediately (by return e-mail) and proceed to its destruction, as well as any document attached to it. The sending of e-mails through the Internet is not safe and, therefore, error-free communications cannot be guaranteed, as they can be intercepted, changed, misled or destroyed or they might contain a virus. Any user contacting us through e-mails shall be understood to be assuming these risks.
>
>
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users at cae.wisc.edu
> https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley at tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20110802/cb4cbf80/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/gif
Size: 198 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20110802/cb4cbf80/attachment-0003.gif>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/gif
Size: 3910 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20110802/cb4cbf80/attachment-0004.gif>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/gif
Size: 198 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20110802/cb4cbf80/attachment-0005.gif>


More information about the TRNSYS-users mailing list