[TRNSYS-users] Strange error when connecting to output device

[a8304506 at graduate.hku.hk]

Hello.

When I try to test a multi-dimensional linear interpolator (Type245) written by
myself (see attached file), I get the following error after the first time
step:

"The listed input referenced an output number beyond the allocated outputs for
the connected type.
Unit 3 Type 25 Input 4 Connected to Unit 5 Type 245 Output 1"

The results for the first time step are correct.  However, if I remove the
connection between the interpolator and the online printer, no error is found. 
Can anyone advise what is the cause for the error?  Thank you!

P.S. I also try to use Type581a, but again with error.

Best Regards
LEE, Chun Kwong
Division of Building Science and Technology
City University of Hong Kong

-------------- next part --------------
A non-text attachment was scrubbed...
Name: Test multi-dimensional linear interpolator.rar
Type: application/octet-stream
Size: 50367 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20100226/95bb2efe/attachment-0005.obj>