[TRNSYS-users] Segmentation

[Matias Garcia]

Hi to everyone,

I have a problem with the function segmentation of an active layer in type
56b. I have already made a deck to study the influence of the concrete core
activation in a room, in this deck type 56 simulates a room with 40 m² that
uses segmentation (dividing the active layer in two segments). When I try to
load another room with different geometry but same outputs and inputs (this
time smaller, 29 m²) I obtain the following the problems:
-segmentation doesn´t work because the minimum flowrate of the first segment
is always bigger to the min.desired inlet mass flowrate. when I make bigger
the minimum desired flow rate I have no segmentation, which takes to the
second problem:
-when I don't use segmentation and run the simulation or try to edit the
building from the deck, a message appears with a stop sign and saying "wall
of autosegmentation not found"
After this I can't no longer open my bui. file, neither from the deck nor
direct from TRNbuild.

can anybody help me?

Thanks a lot.


Matias Garcia
   ------------------------------
 Ansprechpartner/Contact:  Matias Garcia Bereich/Division:
Versorgungstechnik Email:  m.garcia at hl-technik.de      Telefon/Phone:  +49
89 992910-19 Fax/Fax:  +49 89 992910-28 GSM/Mobile:
------------------------------

*HL-Technik Engineering Partner GmbH*
Sitz der Gesellschaft: Aidenbachstr. 52 · D-81379 München · Telefon +49 89
724061-0
Büroadresse: Feringastr. 10 b · D-85774 Unterföhring   Geschäftsführer: Prof.
Dr.-Ing. e.h. Klaus Daniels   Registergericht: Amtsgericht München, HRB
175055   http://www.hl-technik.de · info at hl-technik.de
------------------------------
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/trnsys-users-onebuilding.org/attachments/20090928/b50b8c54/attachment-0001.htm>